A wind plant's production forecast now appears in the fleet forecast view and on the plant's forecast strip as a five-day forecast with the wind speed at 10 m and at hub height. It settles about six hours behind real time.
An event's lost energy no longer reads too low when the plant's loggers were down over the window. The estimate now uses satellite irradiation, scaled by the plant's own performance ratio over the week before.
Historical plant data can now be imported from its data logger archives at a chosen resolution (5-minute, 15-minute, or the original), with a minimum of 3 years of coverage. While the import runs, the plant's pages show an import banner with its progress.
A reading that briefly showed an energy counter at zero or a nonsense high value previously re-added the counter's total as new energy. Energy figures in graphs, reports, exports and the battery dashboard now cancel that reading against the next one, so the affected figures fall to what the plant actually produced.
Days that read tens of GWh too high or too low, after a turbine's history was read in again or after a turbine fell silent, now show what the turbines actually produced. The corrected figures appear in the day, week, month and year views and on the day power curve.
A feed-in meter's own reading is used again on bright days, and the day counts as "measured" instead of "integrated". Before, a high reading was thrown out as impossible and replaced by the total added up from the inverters, or by zero where there was no substitute.
A plant's expected monthly yield now allows for panel ageing counted from the day the plant was built, not from the day Mirox started collecting its data. Expected figures fall where the plant is older than its data, and no ageing is applied where no build date is recorded.
An inverter, a string or a combiner box opened from the analysis page showed its produced, expected and lost energy a thousand times too high — kWh labelled as MWh — and the battery overview showed DC power the same way. Both read correctly again.
A solar plant without a feed-in meter can now be given a virtual one with "Add Virtual Meter" on the plant's "Feed-in Meters" tab. The on-site agent then reports the plant's grid power and total grid energy as the sum of its inverters, as estimates rather than measured readings.