Skip to content

August 2026

Changes released in August 2026.

Open in the full timeline

Web appFeatureMajorAlerts & events

Inverters now show when switched off, tripped or reporting a fault

Inverters now show what they report about themselves: "Stopped by command" when one was switched off, "Protective stop" when its protection tripped, and "Device fault" when the machine reports a fault the measurements cannot show. The maker's own wording and how often it was raised are shown alongside.

mirox 2.15.367 – 2.15.375
Read more in the documentationInverter status codesEvents
Web appFeatureAlerts & events

Inverter status codes now open events for stops and self-derating

The status code an inverter reports about itself now opens an event when the device was stopped by command, tripped on its protection, raised a safety alarm or is throttling itself back. The health column shows "Stopped by command" and "Protective stop", and every code one inverter reports is held in a single event.

mirox 2.15.361 – 2.15.366
Read more in the documentationInverter status codes
AgentFeatureAlerts & events

Battery alarms now appear in a plant's event list

Alarms that NR Electric converters and Linyang battery containers raise about themselves now appear in the plant's event list, and an alarm closes again as soon as the device clears it. Each alarm shows how serious it is, and a Linyang alarm names the racks affected. Plants receive this with their next agent update.

mirox-agents 3.1.416 – 3.1.417mirox 2.15.361 – 2.15.366
Web appFeatureMajorAlerts & events

Inverters that need a service visit are now flagged while producing

An inverter at full output but showing wear is now flagged with "Elevated temperature", "Insulation weakening", "Phase imbalance" or "Efficiency declining". Each problem is marked on the component and listed separately.

mirox 2.15.296 – 2.15.309
Read more in the documentationEvents
Web appFeatureAlerts & events

The connection list now shows why an inverter has gone silent

Each inverter in the monitor's connection list now leads with the reason it cannot be reached: an open outage on the network device its data logger sits behind, naming that logger. Such an inverter counts as a connection issue at once, instead of only after an hour without a signal.

mirox 2.15.214 – 2.15.224
Read more in the documentationNetwork devices
AgentFeatureAlerts & events

An irradiation sensor that stops measuring is now reported

An irradiation sensor is now flagged when it reads zero while a neighbouring sensor or the plant's own production shows the sun is up. A confirmed defect also sends a notification.

mirox-agents 3.1.227 – 3.1.232mirox 2.15.166 – 2.15.172
Web appFeatureMajorAlerts & events

The monitor page now shows each plant's open events

A "Status" column on the monitor page shows a green checkmark when all is well, otherwise how many problems are open and how serious they are. Selecting it opens "Active events": everything still going on at that plant, grouped by type, each row linking to the part it concerns.

mirox 2.15.152 – 2.15.159