Skip to content

Changelog

Every change to Mirox, grouped by month. Filter by group or by kind of change.

Clear filters

November 20262

Web appFixMajorCurtailment & grid limits

The inverter limit now uses the complete datasheet total

The inverter limit now uses the sum of a plant's complete inverter datasheets when no manual value is set. The limit shows on the plant's power graph, forecast strip, alert text and outage-loss export, and the on-site agent clips at it.

mirox 2.15.891 – 2.15.905
Web appFeatureMajorCurtailment & grid limits

The "Park control" tab shows grid and marketer power limits

On a solar plant's analysis page, the "Park control" tab now shows the grid operator's and the direct marketer's power limit per segment, in percent or watts, with a week or month line graph.

mirox 2.15.887

September 20263

Web appFixMajorCurtailment & grid limits

Raw wind curtailment columns no longer come back empty

The raw curtailment columns of a wind plant settled as "Spitz Wind (power curve)", "Spitz Wind light (reference wind speed)" or "Pauschal Wind (flat rate)" no longer come back empty in exports. They now carry the value.

mirox 2.15.580
Web appFeatureMajorCurtailment & grid limits

A wind plant's "Turbines" page now shows curtailment losses by party

A wind plant's "Turbines" page now shows the energy lost to the grid operator, the direct marketer, environmental limits, stop commands and turbine faults. The losses are drawn as stacked areas on the day graph, as segments of the daily, weekly and monthly bars, and as a "Lost in total" figure.

mirox 2.15.468 – 2.15.483
Web appFixMajorCurtailment & grid limits

The dashboard's curtailment now comes from the settled figures

The dashboard's curtailment chart and cards now show the same settled figures as a plant's production page, with quarter-hours not yet settled filled in close to live. Curtailment from before June 2026 is no longer shown on the dashboard because it came from an older calculation, while figures already issued keep their value.

mirox 2.15.447 – 2.15.456

August 202612

Web appFixMajorCurtailment & grid limits

Curtailment figures at battery plants no longer read too high

At plants with battery storage, curtailed energy and the compensation shown against it now come from what the inverters produced, and fall where they read too high. The feed-in meter sits behind the battery, so quarter-hours spent charging looked like no production at all and were claimed in full.

mirox 2.15.376 – 2.15.393
Web appFixMajorCurtailment & grid limits

A limit matching the grid connection no longer counts as curtailment

Curtailed energy and the compensation shown against it now fall at plants whose grid connection is smaller than their inverters. A limit from the direct marketer that merely restates full output was counted as curtailment all day long and is now judged against the smallest of panel peak, inverter rating and grid connection.

mirox 2.15.367 – 2.15.375
Web appFixMajorCurtailment & grid limits

Flat-rate compensation is now measured against the last valid period

For plants settled on the flat-rate method, a curtailment is now measured against the power in the last valid period before it, rather than the highest power found earlier. Curtailed energy and compensation fall wherever the old rule lifted them, while figures already issued keep their value until a month is rebuilt.

mirox 2.15.310 – 2.15.329
Web appFixMajorCurtailment & grid limits

Curtailment rows no longer show a figure from another calculation

Where the data a plant's settlement method needs has not been published yet, lost energy and compensation worked out a different way were shown as the plant's own. The row and its dialog now read "Satellite data not yet available" instead, or "No usable measurement data" where the gap is permanent.

mirox 2.15.296 – 2.15.309
Web appFixMajorCurtailment & grid limits

Curtailment figures no longer count night-time quarter-hours

Curtailment running into the night no longer counts energy from the irradiation sensor's night-time reading, a quarter-hour below 5 W/m² now counting as zero. Curtailed energy and the compensation shown against it fall at plants settled from measured irradiation, for instructions reaching into the evening or early morning.

mirox 2.15.274 – 2.15.278
Web appFeatureMajorCurtailment & grid limits

The "Production" page now lists each settled curtailment

A "Curtailments" section on a plant's "Production" page now lists every settled curtailment and every live detection in the period shown, each with its window, its Ausfallarbeit, how it was settled and the compensation. The graphs now draw the same figures, so the last days of a period stay empty until the settlement has run.

mirox 2.15.274 – 2.15.278
Web appFeatureMajorCurtailment & grid limits

A plant's regulating signals now appear on a "Control Units" tab

A new "Control Units" tab on a plant's components page now lists the signals the plant is regulated by: the cap from the grid operator, the cap from the direct marketer, and the setpoint the plant controller applies. Each signal names the data logger reporting it and can be renamed, hidden or given a note.

mirox 2.15.261 – 2.15.273
Read more in the documentationComponents
Web appFixMajorCurtailment & grid limits

Curtailed energy and compensation before mid-May 2026 rise

Curtailed energy and the compensation shown against it rise for periods before mid-May 2026: quarter-hours that carried no measurement now count, worked out from the plant's own irradiation sensors and feed-in meters. Plants settled on the flat-rate method get figures there for the first time.

mirox 2.15.253 – 2.15.260
Web appFixMajorCurtailment & grid limits

Excluded curtailments now stay out of the settlement

A curtailment episode excluded with "Exclude from settlement" is now left out of the month's curtailed energy and compensation. Until this release the exclusion was recorded, but the month was settled as though nothing had been excluded.

mirox 2.15.243 – 2.15.252
Web appFixMajorCurtailment & grid limits

Curtailment figures no longer count a limit near full power

A limit from the grid operator or the direct marketer left between 85 % and full power no longer counts as a curtailment, even where it does curtail. Curtailed energy and the compensation shown against it drop at plants whose limit sat in that band, at some for a whole month.

mirox 2.15.235 – 2.15.242
Web appFeatureMajorCurtailment & grid limits

The monitor list now shows live power and the limits per plant

The monitor list now has a "Live" column showing the power each plant is feeding into the grid, refreshed every 10 seconds. Below it stand the plant's two power limits, from the grid operator and from the direct marketer, each coloured only while it is holding the plant back.

mirox 2.15.198 – 2.15.213
Web appFeatureMajorCurtailment & grid limits

A detected curtailment can now be excluded from the settlement

Curtailment episodes detected at a plant now appear in the plant's events as their own entries, with the limit that applied and the period covered. "Exclude from settlement" on an entry leaves it out of that month's curtailment figures, and "Re-include in settlement" puts it back.

mirox 2.15.198 – 2.15.213

July 20264

June 20263